Sanris Returns Policy Genuinely faulty goods will be replaced or money refunded, however we must be advised of any faulty goods upon receipt of the item. Text a picture of your item to or email to info qualifiedhardware. For additional information, see the Global Shipping Program terms and conditions — opens in a new window or tab. Customers should satisfy themselves that any iek choice made is suitable for their intended purpose or use. Payment We accept payment by: No returns can be accepted on special order products.
|Published (Last):||20 October 2013|
|PDF File Size:||12.40 Mb|
|ePub File Size:||16.78 Mb|
|Price:||Free* [*Free Regsitration Required]|
The relay must face up towards the keypad wire harness con- nector P2. Use the following steps to wire these relays. Testing the Keypad After installing the keypad, IEI recommends that you perform the keypad self-test once a year, to ensure that the keypad works prop- erly.
To perform the self-test, with the unit powered up, press the The default Master Code is The default code is User 2, when programmed, is the supervisor code. Troubleshooting Refer to this section if the e keypad is not operating correctly as described in this manual. Problem Solution The e keypad is designed to monitor the input voltage and this is an indication of The LEDs are slowly under-voltage. Programming Mode Loopback If the master code is either not working or forgotten, power down the system, connect the wire harness as shown in Figure 12 below, and then power the system up again.
Next, change your master code and power down the system and restore the wire har- ness to its original configuration and power the system back up. Warranty International Electronics Inc. IEI does not assume
Nortek IEI 232e Standalone Installation And Programming Manual
212iLW: Indoor / Outdoor Flush-mount Weather Resistant Keypad
IEI Linear Corp IEI 212w Style Flush Mount Weather Resistant Keypad (0-211222)